Hilti SI-AT-22 Manual De Instrucciones página 11

Scanner type
USB interface
5 Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on
the product.
5.1 Inserting torque module
WARNING
Risk of short circuit !
▶ Before inserting the torque module, make sure that the contacts on the
torque module and the contacts on the impact wrench are free of foreign
matter.
WARNING
Risk of injury by a falling torque module !
▶ Check that the torque module is secure on the impact wrench.
▶ Push the torque module on to the impact wrench from the front until it
engages with an audible click.
5.2 Inserting the battery
WARNING
Risk of short circuit !
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the torque module are free of foreign matter.
WARNING
Risk of injury by a falling battery !
▶ Check that the battery is secure on the torque module.
▶ Push the battery on to the torque module from the front until it engages
with an audible click.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Removing torque module
1. Remove the battery.
2. Press and hold down the release button (2) of the torque module.
3. Pull the torque module forward and off the impact wrench (3).
*2343814*
2
2
3
2343814
Camera / scanner (imager)
Type C, USB 2.0
English 7