Publicidad
Idiomas disponibles
Idiomas disponibles
Each stretch should last approximately
30 seconds, do not overexert the
muscles. If you feel pain, STOP.
Keep these instructions safe for
future use.
1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there
Fig.1:
The assistance of a second person
is recommended when assembling
this unit.
(1)
Main body.
(64) (64) Front support with wheels
(66) Rear rail support.
(68) Seat rail.
(84R) Right footrest.
(84L) Left footrest.
(69) Seat.
(101) Footrest support spindle.
(113) Transformer.
NUTS & BOLTS.
(111) Allen screw M-8x15.
(112) Flat washer M8.
Allen key 6mm.
Allen key 5mm.
2.- UNPACKING.-
After opening the box, remove the
protection (131) by loosening screws
(132). Next, take out is the seat rail
(68) and the seat (69), as shown in
Fig.2.
Next, turn the whole assembly to the
left (anticlockwise), Fig.3.
3.- FITTING THE FRONT
SUPPORT.-
Take the front support (64) and insert
it into the main body (1), Fig. 3, secure
it using screws (111) along with the
washers (112), Fig.3.
Remove the rear protectors (P), Fig.3,
and turn the machine so that it rests
on the supports (6) and (64), Fig.4.
4.- FITTING THE FOOTREST
SPINDLE.-
Once the machine is positioned as
shown in Fig.4, take the footrest (101)
and position it on the main body (1),
Fig.4, secure it using screws (111).
Next, remove the protectors (J) and
the belt safety support (131), Fig.4.
Position the monitor (106) in the
direction of the arrow, at a visible
angle.
5.- FITTING THE SADDLE.-
Position the saddle (69), Fig.6, on the
saddle support (70), Fig.6A, lining up
the holes and secure using screws
(111) and knob (5).
6.- FITTING THE ALUMINIUM
RAIL.-
Insert the aluminium rail (68) onto the
main body (1) in the direction of the
arrow, Fig.6, fit the bolts (111) (5) and
tighten securely.
7.- FITTING THE REAR SUPPORT.-
Position the support (66) at the top of
the rail (68), Fig.7.
Fit the bolt (111), and tighten securely.
8.- FITTING THE FOOTRESTS.-
Take the right-hand footrest (84R) and
fit it onto the spindle (101), Fig.8. Take
screws (111) and screw them into the
end of the right-hand spindle using the
5mm Allen key to tighten them.
Next, take the left-hand footrest (84L)
and fit it onto the spindle (101), Fig.8.
Take screws (111) and screw them into
the end of the left-hand spindle using
the 5mm Allen key to tighten them.
10
Publicidad
