LG WD1351RD Manual Del Propietário página 13

I nstallation
Level adjustment
Adjustable Adjustable
feet feet
In case of auto leveling foot
1. Adjusting the washing machine level properly prevents excessive
noise and vibration.
Install the appliance on a solid and level floor surface, preferably in
a corner of the room.
Timber or suspended type flooring may contribute to
NOTE
excessive vibration and unblance errors.
2. If the floor is uneven, adjust the adjustable feet as required. (do
not insert pieces of wood etc. under the feet)
Make sure that all four feet are stable and resting on the floor and
then check that the appliance is perfectly level. (use a spirit level)
※ ※ After the washer is level, tighten the lock nuts up towards of the base of
the washer. All lock nuts must be tightened.
In the case that the washing machine is installed on a raised
NOTE
platform, it must be securely fastened in order
to eliminate the risk that it might fall off.
❊ Diagonal Check
When pushing down the edges of the washing machine top plate diagonally, the
machine should not move up and down at all. (Please, check both of two directions)
If machine rocks when pushing the machine top plate diagonally, adjust the feet again.
The right rear foot of the washing machine is an auto leveling foot.
Unlike with the adjustable feet, adjusting the auto leveling foot bolt
may cause noise or vibration.
❊ Check the auto leveling foot's state
Case1. Floating from floor
• Raising the front left adjustable foot will press the
auto leveling foot to the floor.
Case2. Auto leveling foot fully pressed
• Raising the adjustable feet at the right front and left
back corners will release the auto leveling foot.
13