Publicidad
Idiomas disponibles
Idiomas disponibles
H
ow to use washer
Add Load
Use this function to add loads or remove the
foreign material.
• How to use "Add Load"
- Press the "Add Load" button.
- Close the door after add loads or remove
the foreign material(e.g. coin or pin etc.)
- Press the "Start/Pause" button.
• Open the door when "Door Lock" is off after
checking the safety.
• Results when choosing "Add Load" during
cycles
- When the tub is spinning: Tub stops and
"Door Lock" is off.
- When water temperature in the tub is
higher than 45°C: "Add Load" is not
available with short warning sound for
safety.
- When lots of water is in the tub: "Door
Lock" is off after draining by safe water
level.
• "Add Load" doesn't work when "Tub
Cleaning" course is in progress for safety
NOTE
Put the laundry into the tub completely.
Laundry caught in between door closing
part can damage door packing(rubber
part) and might cause failure.
24
Time Delay
Preparing washing before starting "Time Delay"
- Turn on the water tap.
- Load laundry and close the door.
- Place the detergent and fabric softener in
the drawer.
• How to set "Time Delay"
- Press Power(
- Turn the Program dial to select
the program you require.
- Press Time Delay button and set the
desired time.
- Press the Start/Pause(
• If Time Delay button is pressed, "3:00" is
displayed. The maximum delayed time is
19:00 hours and the minimum time is 3:00
hours.
• Each pressing of the button advances time
delay by one hour.
• To cancel the time delay, press the
Power(
) button.
• Time Delay is 'expected time' from the
present to the completion of washing cycle
or selected process (Wash, Rinse, Spin).
• According to the condition of water supply and
temperature, the delayed time and the actual
washing time may vary.
) button.
) button.
Publicidad
