Thermador Pro Harmony Professional Serie Guia De Instalacion página 14

en-us Installation procedure
NOTICE:
To avoid risk of damage to the range oven door, do not lift,
push, or pull the range by holding the door handle.
Requirement: You have removed the oven door.
1.
CAUTION DO NOT attempt to lift the unit by hold-
ing the oven's upper heating element.
Lift the range off of the packaging base. Reach inside
the top of the oven cavity to locate a ridged area near
the front of the oven.
Make sure that the circuit breaker is off and then plug
2.
the range cord into the electrical outlet.
Dampen the countertop and floor at the bottom of the
3.
opening with soapy water.
Slide the range into the opening. Be careful not to dam-
4.
age countertops, floors, or warming drawer front. Do not
apply pressure to the cooktop when sliding the range
into position. Be careful not to crimp the flexible electri-
cal connector.
Install the oven door. → Page 14
5.
Check proper installation.
6.
– The cooktop should rest lightly on the countertop.
– There should not be any gap between the countertop
and the cooktop; however, the weight of the range
must not rest on the countertop.
– Look under the range to verify that both back legs are
resting solidly on the floor.
– Also verify that the left range leg is retained by the
anti-tip bracket.
7.3 Adjusting the toe kick panel
Remove the toe kick panel screws using a T-20 star-
1.
head screwdriver.
14
Relocate the toe kick panel at one of the five screw hole
2.
positions. Reinstall the star-head screw.
Repeat with the remaining toe kick panel screws, assur-
3.
ing the toe kick panel is level.
The toe kick panel should maintain a minimum
½'' (12.7 mm) clearance above the floor.
7.4 Reinstalling the oven door
Hold the door firmly in both hands. Grip it on either side,
1.
not by the handle.
Tilt the door back slightly towards you at an angle that
2.
would open the door about 7" (18 cm) at the top.
Slide the hinges into the slots
3.
and lower the door straight down
The angle of the door may need to be adjusted slightly
to allow the hinges to engage properly and the door to
be lowered into place. The door should lower about
3/4" (2 cm) and stop. If it does not, the hinges have not
engaged properly and the door could fall if it is released.
Once both hinges are fully engaged, gently open the
4.
door until it is fully open.
as far as they will go
⁠ .