TriPollar STOP Vx 2 Manual De Instrucciones página 11

11
TREATING YOUR SKIN
To treat your skin using the TriPollar Stop VX2 device:
1. Cleanse and dry the treatment area.
2. Apply a very thin, even layer of TriPollar Preparation Gel over the entire treatment areas.
This gel must be used during the entire treatment session. Your skin may feel a warm
sensation when the gel is applied.
3. Turn the device ON by pressing the Power button (FIG.9). Important: All Leds should
turn on briefly, followed by a steady single white led – this insures all Leds are operational.
Note: A long press of the Power button turns the device OFF.
4. Select the RF power setting (Low/Medium/High) that is most comfortable for you. When
the white indicator light shows a single white light illuminated (FIG.10), the device is
operating at the Low power level. You can press the Power button again to change the
power level (Fig.11, Fig.12) the white LEDs will light up according to the level chosen.
Important: During your first treatment session, it's recommended to use the Low
power setting and then adjust the power level according to your skin's tolerance for
subsequent treatments.
ON/OFF
FIG.9
Treatment:
5. Divide the face to 3 treatment areas (FIG.13):
Right cheek
•
Left cheek
•
Forehead
•
6. Place the device on your skin, make sure to apply a slight pressure in order to
assure a full contact between the electrodes and the skin.
7. Once the device is placed on the skin, the Turbo RF will start. Turbo RF will be
initiated once at the beginning of the treatment or if a new level or mode is
chosen.
LOW RF
FIG.10
MEDIUM RF
FIG.11
HIGH RF
FIG.12