TriPollar STOP Vx 2 Manual De Instrucciones página 12

8. Start moving the device in a very slow circular motion on a small part of your
treatment area (approximately twice the size of the treatment head), slowly
heating your skin to the optimal temperature (FIG.14).
Important: Be sure to constantly move the device slowly over the skin to
ensure proper heating of the treated area. Do not keep the device on one
place without movement.
9. Once the orange indicator light illuminates followed by a 'beep' sound, you have
reached the optimal temperature. Continue the same slow circular motion for a
few moments and then gradually enlarge your movements in the treatment area.
Proceed with this technique covering the entire treatment area, making sure the
orange indicator light is illuminated as much as possible during the treatment.
As you move from one treatment area to another (FIG.13), the orange indicator
light may turn-off if the temperature of the skin is not warm enough.
10. Continue working on the entire treatment area in a slow circular motion for 3-4
minutes. Make sure to maintain a uniform heating while covering the entire
treatment area. Treatment can be augmented by "lifting" movements from the
jaw line upwards toward your cheeks.
11. Once you finished the 3-4 minutes of treatment, you can proceed to the next
treatment area repeating steps 6-10.
12. For jaw line treatment switch to RF + DMA mode by pressing on the DMA button
Make sure that the Blue indicator light turns ON.
The DMA level will start to operate according to the last RF level chosen. You can
press the Power button again to change the RF+DMA power level, the white
LEDs will light up according to the level chosen. It's recommended to start at the
Low RF+DMA.
Important: Use the RF + DMA mode ONLY on the jaw line area (FIG.15).
Do not use on other facial areas.
FIG.13
TREATMENT
AREAS
FIG.14 FIG.15
12