TriPollar STOP Vx 2 Manual De Instrucciones página 13

13
13. Start moving the device using a very slow linear motions along the jaw line.
14. To ensure optimal results, use the device for 3-4 minutes on each side. After the
entire treatment area has been treated, the treatment session is complete. As a
natural result of the treatment, the skin may show some redness (erythema) and
minor skin swelling (edema) in the treatment area. Both should disappear after a
short time.
15. Press the Power button for two seconds to turn the device OFF.
16. Unplug the power supply from the electrical outlet.
17. Gently remove the TriPollar Preparation Gel from your skin and wash your face
thoroughly. You can apply a moisturizer if desired.
18. Clean the electrodes of the device with a damp cloth or paper towel and cover the
device tip with its protective cover.
Warning: Do not submerge the TriPollar Stop VX2 device under water.
SAFETY MECHANISM:
The device's automatic temperature-optimization mechanism protects the skin from
overheating. When the skin has reached the maximal temperature, the energy source
will shut down automatically.
Important:
The orange light is ON when the skin temperature in the treatment area is sufficiently
heated and is OFF when it is not.