Sunny Health & Fitness SF-B1709 Manual Del Usuario página 18

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at
8669).
ASSEMBLY INSTRUCTIONS
support@sunnyhealthfitness.com
STEP 1:
Attach 2 Adjusting Pads (No. 5) to the Rear Stabilizer
(No. 3) by using Spanner (No. 88).
Remove 4 Hexagon Socket Head Screws (No. 8), 4
Flat Washers (No. 7) and 2 Shipping Tubes (No. 35)
from the Main Frame (No. 1) with Allen Wrench (No.
87).
Attach the Front & Rear Stabilizers (No. 2 & No. 3) to
the Main Frame (No. 1) using 4 Hexagon Socket Head
Screws (No. 8) and 4 Flat Washers (No. 7) that were
just removed. Tighten and secure with the Allen Wrench
(No. 87).
NOTE: You can discard the Shipping Tubes (No. 35) or
save them for future packaging or transportation.
STEP 2:
IMPORTANT! Read instructions carefully. Failure to
follow instructions may cause permanent damage to your
bike.
Remove the Left & Right Nylon Nuts (No. 59L/R) located
on the Pedals (No. 15L/R). The Right Nylon Nut (No. 59R)
is white on the inside. The Left Nylon Nut (No. 59L) is blue
on the inside.
Screw the Left Pedal (No. 15L) counter-clockwise into the
Left Crank (No. 12L) by using the Spanner (No. 89). Once
it is properly screwed into the place, use the Wrench (No.
89) to hold the bolt of the pedal and screw the Left Nylon
Nut (No. 59L) clockwise to the thread end of the Left Pedal
(No. 15L) securely with Spanner (No. 88).
Screw the Right Pedal (No. 15R) clockwise into the Right
Crank (No. 12R) by using the Wrench (No. 89). Once
properly screwed into the place, use the Spanner (No. 89)
to hold the bolt of the pedal and screw the Right Nylon Nut
(No. 59R) counter-clockwise to the thread end of the Right
Pedal (No. 15R) securely with Spanner (No. 88).
18
or 1-877-90SUNNY (877-907-