Sunny Health & Fitness SF-B1709 Manual Del Usuario página 20

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at
8669).
Fig. A
Fig. B
support@sunnyhealthfitness.com
STEP 4:
Thread Extension Wire 1 (No. 24) into Main Frame
(No. 1). Insert Handlebar Post (No. 4) into Main
Frame (No. 1) and set at suitable height. Then insert
Spring Knob (No. 13) and tighten to secure. Finally
connect Extension Wire 1 (No. 24) to Sensor Wire
(No. 23).
NOTE: To avoid damaging the wires, do not pinch
the wires when assembling.
STEP 5:
Remove Hexagon Socket Cap Screw (No. 38)
from Handlebar Post (No. 4) using Allen Wrench
(No. 86). Then remove Bolt (No. 28) and Washer
(No. 93) from Triangle Knob (No. 26). Place
Handlebar (No. 22) onto the groove of Handlebar
Post (No. 4).
NOTE: Do not slide the Handlebar (No. 22) fully into
the groove of Handlebar Post (No. 4) yet.
Insert Bolt (No. 28) into the hole in the Handlebar
(No. 22) from the bottom, then tighten with Washer
(No. 93) and Triangle Knob (No. 26). Now you can
slide the Handlebar (No. 22) fully into the groove of
Handlebar Post (No. 4).
CAUTION: Hold head of Bolt (No. 28) and make
sure head of Bolt (No. 28) fits into the groove of
Handlebar Post (No. 4) while you slide the
Handlebar (No. 22) onto the Handlebar Post (No.
4). (See Fig. A).
Fig. C
Put Hexagon Socket Cap Screw (No. 38) into the
hole in the Handlebar Post (No. 4) (See Fig. B) and
tighten with Allen Wrench (No. 86).
Finally connect the Extension Wire 1 (No. 24) and
Extension Wire 2 (No. 37). (See Fig. C)
20
or 1-877-90SUNNY (877-907-