essentiel b ELT 712-2b Instrucciones De Uso página 34

Opening the door
A special safety device prevents the
door from being opened immediately
after the end of the cycle.
Wait for 2 minutes after the wash
cycle has finished and the "Door
Security" light has gone out before
opening the door.
PROGRAMME selector with OFF
position
When the programme selector is turned
the display lights up to show the settings
for the programme selected.
For energy saving, at the end of the
cycle or with an inactivity period, the
display level contrast will decrease.
N.B.: To switch the machine off, turn
the programme selector to the OFF
position.
Press the START/PAUSE button to start

the selected cycle.
Once a programme is selected the

programme selector remains stationary on
the selected programme till cycle ends.
Switch off the washing machine by

turning the selector to OFF.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
Press to start the selected cycle.

When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
ADD OR REMOVE ITEMS AFTER THE
PROGRAMMES HAS STARTED (PAUSE)
Press and hold the START/PAUSE

button for about 2 seconds (some
indicator light and the time remaining
indicator will flash, showing that the
machine has been paused).
Wait 2 minutes until the safety device

unlocks the door.
Before you open the door, please
check water level is below the door
opening to avoid flooding.
After you have added or removed items,

close the
START/PAUSE button (the programme
will start from where it left off).
CANCELLING THE PROGRAMME
 To cancel the programme, set the
selector to the OFF position.
DELAY START button
This button allows you to pre-programme

the wash cycle to delay the start of the
cycle for up to 24 hours.
To delay the start use the following

procedure:
- Select the required programme.
- Press the delay start button once to
activate it (h00 appears on the display)
and then press it again to set a 1 hour
delay (h01 appears on the display). The
pre-set delay increases by 1 hour each
34
door and press the