essentiel b ELT 712-2b Instrucciones De Uso página 36

To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
To reactivate the spin cycle press the

button until you reach the spin speed you
would like to set.
It is possible to modify the spin speed

without pausing the machine.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle without
particularly unbalanced load. This
reduces the noise and vibration in the
machine and so prolongs the life of
your machine.
KEY LOCK
Pressing simultaneously

TEMPERATURE SELECTION and SPIN
SPEED for about 3
machine allows you to lock the keys. In
this way, you
accidental or unwanted changes if a
button on the
accidently during a cycle.
The key lock can be simply cancelled by

pressing the two buttons simultaneously
again or turning off the appliance.
foaming. If the
load or on
the buttons
seconds, the
can avoid making
display is pressed
36
Digital Display
The display's indicator system allows you to
be constantly informed about the status of
the machine.
1) OPTIONS INDICATOR LIGHTS
The indicator lights show the options that
can be selected by the relevant button.
2) CYCLE DURATION
When a programme is selected the

display automatically shows the cycle
duration, which can vary, depending on
the options selected.
During the initial filling phase of the cycle

the machine calculates the actual cycle
time needed based on the load size,
content and options selected. The real
time of the wash will then be displayed.
This time can recaulculate during the
wash depending on detergent levels and
load balancing.
3) DOOR LOCKED INDICATOR LIGHT
 The indicator light is illuminated when the
door is fully closed.
Close the door BEFORE selecting the
START/PAUSE button.
When START/PAUSE is pressed on the

machine with the door closed, the
indicator will flash momentarily and then
illuminate.