Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Range: 1 - 6 Nm
Fine scale: 0.1 Nm
Deviation: ± 4%
Output square drive size (metric): 6.3mm
Output square drive size (imperial): 1/4"
suitable for screws with right hand threads
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This product is designed to tighten right-hand thread screws to a pre-set torque value intended for the
screws.
SAFETY INFORMATIONS
•
Keep children and other persons out of the working area.
•
Do not allow children to play with this tool or its packaging.
•
Do not use the product if it's damaged.
•
Use the product for the intended purpose only.
•
If wrench has not been used or has been in storage for some time, operate it several times at
a low torque setting which permits special internal lubricant to re-coat internaI working parts.
•
When wrench is not in use, keep doing adjustment at lowest torque setting.
•
Do not turn handle below lowest torque setting.
•
Do not continue pulling on the wrench after pre-set torque has been reached and the wrench
has been released. Pressure must be taken off the handle and the wrench allowed to
automatically reset itself, continuing to apply pressure after the wrench has been released, will
result in damage to the part being torque by applying more than the specified amount of
torque.
•
Tool is rugged and designed for shop use, but is also a precision measuring instrument and
should be treated as such.
•
Clean wrench by wiping. Do not immerse in any type of cleaner which may affect special high
pressure lube with which the wrench is packed at the factory.
•
This torque wrench was calibrated and tested before leaving the factory.
•
The wrench is only suitable for measuring torque 1 to 6 Nm
•
Calibration and servicing must be done regularly and is the owner responsibility.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Torque Wrench | 1 – 6 Nm
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 954
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
