LD Systems AMP 106 T Manual De Usuario página 5

This symbol indicates dangers due to high volume levels.
This symbol denotes a device that does not contain any user-serviceable parts.
This symbol indicates additional information on the operation of the product.
SAFETY INSTRUCTIONS
DANGER:
1. Do not open the device and do not perform any modifications.
2. If your device no longer functions properly, if liquids or objects get inside it or if it
has been damaged in any other way, switch it off immediately and disconnect it
from the mains. The device may be repaired only by authorised repair technicians.
3. For devices of protection class 1, the protective conductor must be connected
correctly. Never disconnect the protective conductor. Devices of protection
class 2 do not have a protective conductor.
4. Ensure that live cables are not kinked or otherwise mechanically damaged.
5. Never bypass the device fuse.
WARNING:
1. The device may not be operated if it shows obvious signs of damage.
2. The device may only be installed in a voltage-free state.
3. If the mains cable of the device is damaged, do not operate the device.
4. Permanently connected power cables may only be replaced by a qualified person.
CAUTION:
1. Do not operate the device if it has been exposed to strong temperature fluctuations
(for example, after transport). Moisture and condensate could damage the device.
Do not switch on the device until it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains supply match the values
indicated on the device. If the device has a voltage selector switch, do not connect
the device until it is set correctly. Use only suitable power cords.
3. To completely disconnect the device from the power supply, unplug the power cable or
power adapter from the outlet. It is not sufficient to press the on/off switch on the unit.
4. Only replace the fuse with a fuse of the same type and rating indicated on the device.
5. Make sure that suitable measures have been taken against overvoltage
(e.g. lightning strike).
6. Observe the specified maximum output current on devices with Power Out
connection. Ensure that the total current consumption of all connected devices
does not exceed the specified value.
7. Replace pluggable mains cables only with original cables.
5