Silvercrest SRW 250 A1 Manual Del Usuario E Información De Servicio página 70

SRW 250 A1 Alarm Clock Radio
Tuning to a Station
 Power the device on by pressing the ON/OFF button [2].
 The current frequency is shown briefly on the display [10]. As soon as
the current time is shown, you can press the – [7] or + [8] buttons to
adjust the volume.
 First, select the frequency band you want by holding the
TUNE/BAND button [4]. The current frequency band is shown on the
display [10] by means of FM [23] or AM [24] LEDs.
 Briefly press the TUNE/BAND button [4] and then briefly press the –
[7] or + [8] button a few times to tune the frequency manually. To
search for a station automatically, press and hold the – [7] or + [8]
button. The frequency displays in MHz (for FM) and in kHz (for AM).
For FM, any frequencies with 0.05 MHz are shown by means of the
0.05 LED [18]. If required, move the wire antenna into a different
position or move the device to improve reception.
 You can save a station by pressing and holding the PRESET button [6]
for approx. 1-2 seconds.
 "P" flashes on the display [10], followed by a number between 01
and 20.
 Press – [7] or + [8] to select the station preset you want.
 Press the PRESET button [6] again to save the current station to the
selected preset.
68 - English