Silvercrest SRW 250 A1 Manual Del Usuario E Información De Servicio página 72

SRW 250 A1 Alarm Clock Radio
Setting the Alarm
Make sure that the clock has been set correctly (see the page 66 – Setting
the Time). You can set two different alarm times (ALARM1 and ALARM2).
The alarm time can only be set while the device is powered off. If it is
powered on, press the ON/OFF button [2] to power the device off.
 Press and hold the ALARM1 [3] or ALARM2 [5] button until the hour
display flashes [10].
 Press the – [7] or + [8] button to set the hour. You can also press and
hold the – [7] or + [8] button.
 Press the ALARM1 [3] or the ALARM2 [5] button quickly again to set
the minutes. The minutes flash on the display [10].
 Press the – [7] or + [8] button to set the minutes. You can also press
and hold the – [7] or + [8] button to set the minutes in 10-minute
steps.
 Wait until the display [10] stops flashing or quickly press the
ALARM1 [3] or the ALARM2 [5] button.
70 - English
Please note that you can only set the alarm time while the
numbers are flashing on the display [10]. If no input is
made for a few seconds, the numbers on the display [10]
stop flashing and you will have to repeat the procedure.