Pioneer FS-S40 Manual De Instrucciones página 9

Pairing with the Controller
Refer to the installation illustrations to install. On the rear of
the speakers you will see "SL" or "SR" on the label. Place
the speaker with "SL" at the rear left of the listening
position. Place the speaker with "SR" to the rear right of the
listening position.
When setting up the Controller for the first time
1. As with the speakers you purchased at the same time,
firstly connect the power cord of the unit.
2. After referring to the Quick Start Guide for FS-W40,
connect the Controller and turn the power on. The Initial
Setup screen is displayed automatically on the
television, so use the cursors and ENTER buttons on the
remote controller, following the on-screen instructions to
complete the settings.
If you add this unit later
1. Connect this unit's power cord.
2. Set the input selector on the TV to the position the
Controller is connected to.
3. Turn on the power of the Controller and press SETUP on
the remote controller.
4. Use the cursor and ENTER buttons on the remote
controller and select "Wireless Speaker" → "Scan" →
"Next" on the TV screen.
Scan
Speakers currently paired:
Front Left : Yes
Front Right : Yes
Surround Left : No
Surround Right : No
Subwoofer : No
Ensure all speakers are connected to the power supply.
Next
Cancel
5. When the speaker has been detected, select "Save" to
save the pairing information.
The CONNECT LED
This flashes red when unpaired with the
Controller and lights blue when pairing
is complete. Also, when Wireless
Speaker Standby has been set to on on
the Controller, this lights red when the
Controller is in standby mode.
When submitting the controller or the speakers for
repairs, please submit both the controller and the
speakers.
The optimal positioning for this unit is just above
ear height. Select a flat, stable location to place
the unit.
When attaching to a wall : As shown in the
diagram, this unit has two holes for screws. Use
commercially available fittings to attach to a wall or
hang from the ceiling.
CON NEC T
• Make sure the fittings you choose are capable of
sufficiently sustaining the weight of the unit.
Refer to the instruction manual for the fittings for
other information about installation.
En
M5(Depth 12mm)
60 mm
9