Bimar VT312 Manual De Instrucciones página 12

personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the appliance. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they
must conform to existing safety standards and their current capacity (amperes)
must not be less that the maximum of the appliance.
 The power socket must be easy to reach so the plug can be removed quickly in case
of emergency.
 Do not place the fan on a shelf and/or near sinks or other container of liquids
(minimum distance of 2 meters) to avoid the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could
obstruct the air intake grille; make sure that the front is free of unstable materials
(dust, etc.).

This device is NOT suitable to use it in an explosive environment (in the presence of
flammable substances such as gas, vapor, mist or dust, in atmospheric conditions
when, after ignition, the combustion is spread in the air).
 Make sure that the electric cord is not touching rough, hot or moving surfaces and
not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined
plane (the appliance could upset).
 Do not place the appliance near an open flame, cooking or other heating appliance.
 In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer or a
competent qualified electrician or a person with similar qualifications, in order to
avoid any risk.
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and protection grid.
Attention: always unplug the appliance before you assemble.
If in doubt, have the appliance checked or assembled by a qualified professional
person. For assembly, refer to figure.
12/36