Publicidad
Idiomas disponibles
Idiomas disponibles
It will prevent the blade screw from properly securing the
blade on the spindle. Do not use the saw to cut metal or
masonry. Ensure that any spacers and spindle rings that may
be required suit the spindle and the blade fitted.
1. Make sure that the electrical plug is removed from the
power point.
2. Push down on the operating handle (3) and pull the
release knob (2) to disengage the saw arm (1).
3. Raise the saw arm (1) to its highest position.
4. Using a Phillips head screwdriver loosen and remove
the Phillips head screw that secures the guard retraction
arm (6) to the rotating blade guard (5) (fig. Q).
5. Using a Phillips head screwdriver loosen the Phillips head
screw that secures the blade bolt cover (19) (fig. R).
Q
S
6. Pull the rotating blade guard (5) down then swing it
up together with the blade bolt cover (19). When the
rotating blade guard (5) is positioned over the upper
fixed blade guard (4) it is possible to access the blade
bolt (fig. S).
10|English
R
T
7. Hold the rotating guard (5) up and press the spindle
lock button (18). Rotate the blade until the spindle
locks (fig. T).
8. Use the 6mm hex key provided to loosen and remove
the blade bolt. (Loosen in a clockwise direction as the
blade screw has a left hand thread) (fig. U).
U
9. Remove the flat washer,
outer blade washer and
the blade (fig. V).
10. Wipe a drop of oil onto the
inner blade washer and the
outer blade washer where
they contact the blade.
11. Fit the new blade onto
the spindle taking care
that the inner blade
washer sits behind the blade
(fig. W).
CAUTION. To ensure correct blade rotation, always install
the blade with the blade teeth and the arrow printed on
the side of the blade pointing down. The direction of
blade rotation is also stamped with an arrow on the
upper blade guard.
12. Replace the outer blade washer.
13. Depress the spindle lock button (26) and replace the
flat washer and blade bolt.
14. Use the 6mm hex key to tighten the blade bolt
securely (tighten in an anti-clockwise direction).
V
W
V
Publicidad
