Publicidad
Idiomas disponibles
Idiomas disponibles
Additional safety rules for mitre saws
WARNINGS. Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on
the nameplate of the tool. A power source with a voltage
greater than that specified for the tool can result in
serious injury to the user, as well as damage to the tool.
If in doubt, do not plug in the tool.
Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
Your tool is double insulated for additional protection
against a possible electrical insulation failure within
the tool.
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the blade.
• When operating the saw, use safety equipment including
safety goggles or shield, ear protection, dust mask and
protective clothing including safety gloves.
• Ensure that there is adequate general or localised
lighting.
• Do not use the saw unless the guards are in place.
• Do not use the saw to cut metal or masonry.
• Do not let anyone under 18 years operate this saw.
• Ensure that the operator is adequately trained in the
use, adjustment and operation of the machine.
• Do not use this saw to cut firewood.
• Keep the area free of tripping hazards.
• Report faults in the machine, including guards and saw
blades, as soon as they are discovered.
• Ensure that the machine is always fixed to a bench,
whenever possible.
• Always stand to one side when operating the saw.
• Never use a cracked or distorted saw blade.
4|English
• Never use your hands to remove sawdust, chips or waste
close by the blade.
• Use only blades as recommended by the manufacturer
and which conform to EN 847-1.
• Do not use blades of High Speed Steel (HSS blades).
• If the table insert is damaged or worn, have it replaced
by an authorised service centre.
• Rags, cloths, cord and string and the like should never
be left around the work area.
• Avoid cutting nails. Inspect the workpiece and remove
all nails and other foreign objects before beginning
sawing.
• Support the work properly.
• Refrain from removing any cut-offs or other parts of the
workpiece from the cutting area whilst the machine is
running and the saw head is not in the rest position.
• Do not attempt to free a jammed blade before first
switching off the machine.
• Do not slow or stop a blade with a piece of wood. Let
the blade come to rest naturally.
• If you are interrupted when operating the saw, complete
the process and switch off before looking up.
• Periodically check that all nuts, bolts and other fixings
are properly tightened.
• Do not store materials or equipment above a machine in
such a way that they could fall into it.
• Always hold the saw on parts that are insulated. If you
accidentally cut into hidden wiring or the saw's own cable,
the metal parts of the saw will become "live". Switch off
at the mains and remove the plug immediately.• Never
saw near combustible liquids or gases.
• Note the direction of rotation of the motor and the blade.
• Do not lock the movable guard in the open position and
always ensure that it is working properly, freely rotating
and returning to fully cover the teeth of the blade.
Publicidad
