Publicidad
Idiomas disponibles
Idiomas disponibles
Note. Make sure that the square contacts the flat
part of the saw blade, not the teeth.
8. Rotate the blade by hand and check the
blade-to-table alignment at several points.
9. The edge of the set square
and the saw blade should
be parallel.
10. If the saw blade angles
away from the set
square, adjust as follows.
11. Use an 8mm wrench
or adjustable wrench
to loosen the lock nut
securing the 0° bevel
adjustment screw (10).
Also, loosen the bevel lock (7) (fig. K).
12. Adjust the 0° bevel adjustment screw (10) using a
4mm hex key to bring
the saw blade into
alignment with the
square (fig. L).
13. Loosen the Phillips head
screw holding the pointer
of the bevel scale (8)
and adjust the position
of the pointer so that it
accurately indicates zero
on the scale. Retighten
the screw (fig. M).
14. Retighten the bevel lock
(7) and the lock nut
securing the 0° bevel
adjustment screw (10).
Note. The above procedure
can also be used to check the
angle of the saw blade to the
table at 45º bevel angle. The 45° bevel adjustment screw
(9) is on the opposite side of the saw arm.
9|English
K
L
M
Setting the fence square with the table
1. Make sure that the electrical plug is removed from the
power point.
2. Push the saw arm (1) down
to its lowest position and
engage the release knob (2)
to hold the saw arm in the
transport position.
3. Loosen the mitre locks (15).
4. Rotate the table (12) until the
pointer is positioned at 0º.
5. Tighten the mitre locks (15).
6. Using a 5mm hex key,
loosen the two screws
securing the fence (11) to
the base (fig. N).
7. Place a square against the
fence (11) and alongside
the blade (fig. O).
8. Adjust the fence (11) until
it is square with the blade.
9. Tighten the screws securing
the fence (11).
10. Loosen the Phillips head
screw holding the pointer
of the mitre scale (13)
and adjust it so that it
accurately indicates the
zero position on the mitre
scale (fig. P).
11. Retighten the screw securing
the mitre scale pointer.
Changing a blade
DANGER! Never try to use a blade larger than the stated
capacity of the saw. It might come into contact with the
blade guards. Never use a blade that is too thick to allow the
outer blade washer to engage with the flats on the spindle.
N
O
Publicidad
