CoComm DT200 Manual De Instrucciones página 53

Installation
Follow the following steps to install your SIM card and the various accessories of your
Co-Comm DT200 cordless phone:
1. Disconnect the power adaptor and remove the cover of the battery compartment from
the back of the device to install the micro-SIM card and the micro-SD memory card.
To install the micro-SIM card, slide the metallic cover to the right to unlock it, flip it up,
and place the card following the direction shown in the illustration. Lower the metallic
cover and slide it to the left until it is locked again.
2. Follow the same process if you want to install a micro-SD card, although this time slide
the metallic cover to the left to unlock it, as shown in the illustration. Place the memory
card, and then lower the metallic cover and slide to its initial location to lock it.
1
1 2
2
53