Publicidad
Idiomas disponibles
Idiomas disponibles
7. Intended use
• The Nexxsaw has been exclusively
designed for cutting branches. The saw
is not intended for continuous commer-
cial use.
• The intended use also includes an opera-
tion following the operating instructions.
• In conjunction with the extension handle,
the Nexxsaw can be used as a pruner for
cutting branches.
• Any use beyond these parameters (dif-
ferent media, applying force) or any
changes (reconstruction, no original
accessory) can lead to serious risks and
is regarded as use that is contrary to the
intended purpose.
8. Use
Mounting the saw chain
8.1
(See Fig. C, D, E).
Always wear gloves when handling the
saw chain.
a. Unscrew the head screw (16) coun-
ter-clockwise in order to remove the
sprocket cover (17).
b. Remove the guide bar from the machine
and run the saw chain around it.
Please note the running direction of the
saw chain. The saw chain icon is shown
on the cover.
c.
Run the saw chain over the sprocket
(20) and replace the guide bar on the
chain adjusting screw pin (19).
d. Use an oiler to oil the saw chain and the
sprocket.
e.
Slightly tighten the saw chain with the
chain adjusting screw (7). Use the
included adjustment key (12) to tighten
the screw. For tightening, turn the screw
clockwise.
f.
Re-tighten the sprocket cover (17) with
the head screw (16) on the housing.
Lubrication
8.2
Saw chain must be lubricated when the tool
is in operation.
• Check the amount of remaining oil in the
oil reservoir through the oil inspection
window (21).
7064322-Nexxsaw-V3-7inch-Ma-2209-23.indb 9
7064322-Nexxsaw-V3-7inch-Ma-2209-23.indb 9
• Lightly press the oil supply button (2) to
lubricate the chain.
To refill the oil reservoir
8.3
• Remove the battery from the machine.
• Remove the oil reservoir cap (9) from the
oil reservoir opening.
• Fill the oil reservoir.
• After refilling the reservoir, always screw
the provided oil reservoir cap on the
chain saw.
CAUTION:
• Only use commercially available, biode-
gradable chain oils.
• Do not use engine oil, waste oil or other
mineral oils.
• Never use oil including dust and particles
or volatile oil.
• If the saw makes a rattling noise, the
chain must be lubricated.
Grease the chain of the Nexxsaw regularly
with biodegradable oil.
Adjusting saw head
8.4
(See Fig. F).
The cutting position of the Nexxsaw can be
adjusted by adjusting the saw head:
Caution! Wear safety gloves.
• Remove the battery from the machine.
• Push release button (3b).
• Turn knob (3a) clockwise to adjust the
saw head.
• Adjust the saw head to the desired
position.
• Turn knob (3a) counter clockwise to the
starting position, and make sure that
release button (3b) audibly clicks into
place.
PAY ATTENTION: If release button (3b)
does not click properly, the machine will not
start, this is an extra safety.
Adjusting saw chain tension
8.5
(See Fig. C).
CAUTION: Do not tighten the saw chain too
much. Excessively high tension of saw
chain may cause breakage of saw chain,
wear of the guide bar and breakage of the
sprocket.
CAUTION: A chain which is too loose can
jump off the guide bar.
English
9
07-11-2022 16:50
07-11-2022 16:50
Publicidad
