Publicidad
Idiomas disponibles
Idiomas disponibles
own. Apply only light pressure to the
saw. The chain speed should not be
much slower.
Changing the saw chain
8.9
• Only handle the saw chain with gloves
and remove the battery first!
• Inspect the saw chain and the guide bar
for damage or signs of wear.
• Never put a new saw chain on a worn
guide bar.
• Let each new saw chain break-in first!
• When attaching the saw chain, observe
the running direction!
Kickback
8.10
• The shape of the protection cover (4)
largely eliminates the risk of kickback.
• The saw is optimally protected against
kickback by the protection cover with tip
protection. Never remove the protection
cover (4). There is a risk of injury!
Sharpen the saw chain
8.11
• The saw teeth must be sharpened if the
sawdust becomes powdery, if additional
force is required for the incision, if a
straight incision is no longer possible or
if the vibrations become stronger.
• Blunt saw chains should be
re-sharpened.
• To sharpen the chain use a chain sharp-
ener, make sure you sharpen the chain at
a 30° angle.
• Or have the chain re-sharpened profes-
sionally (advised).
• Replace the saw chain if there is consid-
erable damage that cannot be repaired
by filing.
Cleaning the guide bar
8.12
(See Fig. G).
• Thoroughly clean the notch of the guide
bar.
• Replace the guide bar if the guide groove
is damaged or worn and the saw chain
has too much lateral space.
7064322-Nexxsaw-V3-7inch-Ma-2209-23.indb 11
7064322-Nexxsaw-V3-7inch-Ma-2209-23.indb 11
9. Maintenance, cleaning and
storing
For best performance, always keep the saw
chain and the Nexxsaw in good order.
Remove the battery pack from the tool
before carrying out any adjustment, servic-
ing or maintenance.
• Clean the sprocket area with a brush or
compressed air. (See Fig. H).
• Use a cloth, a paintbrush or a brush to
remove dust and wood splinters. Always
keep the ventilation slots clean and free
from obstructions.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap. Do not use any cleaning or solvent
materials; these can attack the device's
plastic components. Make sure that no
water can get inside the electric power
tool.
• Do not let liquids of any kind enter the
Nexxsaw.
• From time to time check that all screws
are firmly secured.
• Store the Nexxsaw and the accessory
indoors in a dry place that is protected
from dust, dirt and extreme
temperatures.
• Store the Nexxsaw out of reach of chil-
dren and persons in need of supervision.
English
11
07-11-2022 16:50
07-11-2022 16:50
Publicidad
