Publicidad
Idiomas disponibles
Idiomas disponibles
642743-00 CS1030 CS1040L
• Tighten the lever to lock the saw shoe
in place.
• Set depth adjustment of saw such that
one tooth of the blade projects below
the workpiece as shown in figure 8.
7
8
Surface of wood
ADJUSTING THE BEVEL ANGLE
(FIG. 9)
This tool can be set to bevel angles
between 0° and 45°.
• Loosen the locking knob (14) to unlock
the saw shoe.
• Move the saw shoe (6) into the desired
position. The corresponding bevel
angle can be read from the scale (15).
• Tighten the locking knob to lock the
saw shoe in place.
9
15
4/13/06
10:06 AM
Page 8
ATTACHING AND REMOVING THE
BLADE
REMOVING THE BLADE (CS1040L)
(FIG. 10 & 11)
• Keep the spindle lock button (5)
13
depressed and rotate the blade until
the spindle lock engages.
• Loosen and remove the blade retaining
screw (16) by turning it counter-
clockwise using the wrench (10)
supplied.
• Remove the outer washer (17).
• Remove the saw blade (7).
12
10
Tip of tooth
11
ATTACHING THE BLADE (CS1040L)
• Place the saw blade (7) onto the inner
flange (18), making sure that the arrow
on the blade points in the same
14
direction as the arrow on the tool.
• Fit the outer washer (17) on the
spindle, with the raised part pointing
away from the saw blade.
• Insert the blade retaining screw (16)
into the hole.
• Keep the spindle lock button (5)
depressed.
• Securely tighten the blade retaining
screw by turning it clockwise using the
wrench (10) supplied.
8
5
18
17
16
7
10
Publicidad
