Publicidad
Idiomas disponibles
Idiomas disponibles
IF tHe Kettle does boIl dry
If the kettle is operated in accordance with instructions for use, it is unlikely that the kettle
will boil dry. However, in the event that the kettle does boil dry, it is protected by a boil dry,
fail-safe device which will switch the kettle off automatically on sensing a boil dry situation
and keep it switched off until the kettle is refilled with at least the minimum amount of
water. Always allow the kettle to cool for half an hour before reuse if the kettle has boiled dry.
A mesh filter has been integrated into the kettle to reduce the amount of scale residues
entering your beverages or food. The filter is removable for cleaning. To reduce scale
build-up, empty out any residual water after boiling.
How often the filter should be cleaned will vary according to where you live and how often
you use your kettle. Filter should be cleaned whenever there are noticeable deposits left
on the filter and especially if the rate of pouring decreases.
FIlter reMoval/cleanIng/reFIttIng
IMPORTANT: The kettle must be switched off, disconnected from the power outlet
and allowed to cool down completely prior to removing or refitting the filter. Do not
use excessive force, as this might damage the filter or the lid.
1. Empty the kettle and open lid.
2. Grip the top part of the filter with index finger and thumb and
pull upwards. You may have to hold kettle while removing filter.
CAUTION: Keep fingers clear of mesh. Pressing into mesh
may damage filter.
3. To clean the filter, rinse under a tap while brushing it gently
with a soft brush.
4. To refit filter, once again hold filter with index finger and thumb.
Gently push filter back into the kettle until you hear a click. The
filter is now reattached. Gently tug on filter to ensure filter is
attached properly.
5. Rinse out kettle with fresh water and it's ready for use.
FIlter InstrUctIons
en gli sh - 5
Publicidad
