UFESA AC2500 Manual De Instrucciones página 8

●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.
Technical parameters
The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 86 dB(A).
Static electricity
In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1
ON/OFF button
2
Handle
3 Cord rewind button
4
Suction brush fastening clip
5
Plug and cord
6
Outlet filter cover
7
Front cover interlock
8
Suction power slider
9
Bag filling indicator
10 Suction hose
11 Suction telescopic tube with a hook
12
SAFBAG (1 pcs., fitted inside the vacuum)
13
Outlet filter (fitted inside the vacuum)
14
Inlet filter (fitted inside the vacuum)
15
Two-function ending
a
crevice nozzle function
b brush function
16
Combination suction brush
17
Clip for attaching the telescopic tube with a hook
Preparing vacuum cleaner for
operation
1
Insert the end of the suction hose into the vacuum' s
inlet opening. If you hear a click, it means that the hose
has been attached correctly.
2
Connect the other end of the hose (handle) with
the suction tube. In order to do it, press latch "A" and
insert the tube into the hose' s handle so that latch "A"
is blocked in opening "B".
3
Adjust the telescopic suction tube to the desired
length by sliding the slider according to the arrow and
pull the tube out/in.
4
Attach the selected nozzle or brush to the other
end of the suction tube.
5
Combination suction brush may be used to
vacuum hard flooring and carpets. In order to vacuum
hard surfaces - wooden, plastic floors, ceramic tiles,
etc. pull the brush out by pressing the switch on the
suction brush according to the drawing
vacuuming carpets, hide the brush (set the switch on
the suction brush to "
6
Grab the plug (5) and pull the cord out.
When pulling the power cord out, beware
A
of the yellow stripe signaling the end of
the cord. Persistent pulling (pulling on),
may damage the cord. The red stripe is to tell
you that you cannot pull the cord anymore.
7
Insert the plug into the power outlet.
Before you start your vacuum cleaner, make sure the
SAFBAG is fitted inside the vacuum' s compartment
and the inlet and outlet filters are fixed.
8
Switch the vacuum cleaner on by pressing ON/OFF
button (1).
9
Your vacuum cleaner comes with an electronic
power regulator helping you to smoothly regulate its
power. Power can regulated with the slider.
. When
").
B