Publicidad
Idiomas disponibles
Idiomas disponibles
Before the first use, all parts of the appliance that are in contact with food must be
thoroughly washed (see: Cleaning and maintenance).
For the best results, use milk with fat content over 3.0%.
Warm milk frothing
•
Place the tank (5) in the base (6).
Install the required tip inside the tank (5)
•
•
Pour milk into the tank in the volume not exceeding the maximum level -
Place the lid (1) with the sealing gasket
•
Press the button (8) twice. The control light
•
•
The appliance will switch off automatically, and the control light will go off. The appliance
may be turned off at any time with the button (8).
Then remove the lid (1).
•
While holding the appliance by the handle (3), remove the tank (5) from the base and
•
pour out the milk to a cup. If needed, use a wooden spoon so as not to damage the coat
of the tank.
Cold milk frothing
•
Place the tank (5) in the base (8).
Install the required tip inside the tank (5).
•
•
Pour milk into the tank in the volume not exceeding the maximum level -
Place the lid (1) with the sealing gasket.
•
Press the button (8) twice. The control light will go on to start the frothing process.
•
•
The appliance will switch off automatically, and the control light will go off. The appliance
may be turned off at any time with the button (8).
Then remove the lid (1).
•
While holding the appliance by the handle (3), remove the tank (5) from the base and
•
pour out the milk to a cup. If needed, use a wooden spoon so as not to damage the coat
of the tank.
Heating up milk
•
Place the tank (5) in the base (6).
Install the required tip inside the tank (5).
•
•
Pour milk into the tank in the volume not exceeding the maximum level -
Place the lid (1) with the sealing gasket.
•
Press the button (8) twice. The control light
•
start.
•
The appliance will switch off automatically, and the control light will go off. The appliance
may be turned off at any time with the button (8).
Then remove the lid (1).
•
While holding the appliance by the handle (3), remove the tank (5) from the base and
•
pour out the milk to a cup.
NOTE. Do not pour milk above the maximum level for the given function.
will go on to start the frothing process.
will go on and the heating process will
EN 11
Publicidad
