Metra 95-8242G Instrucciones De Instalación página 3

1. Secure the (4) panel clip legs to the
radio trim panel using (8) Phillips screws
provided. Attach the (4) factory panel
clips to the legs. (Figure A)
2. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
4. Secure the radio assembly into the dash
using the factory screws.
5. Snap the radio trim panel over the
radio, then reassemble the dash
in reverse order of disassembly to
complete the installation.
KIT ASSEMBLY
(Figure A) (Figure B)
3
REV. 8/6/2019 INST95-8242G