Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL SAFETY INSTRUCTIONS (CONTINUED)
•
If the equipment should start to vibrate abnormally, STOP the engine/motor and check immediately
for the cause. Vibration is generally an indication of trouble.
•
To reduce fire hazard, keep engine/motor exterior free of oil, solvent, or excessive grease.
•
Never attempt to adjust ASME safety valve. Keep safety valve free from paint and other
accumulations.
An ASME code safety relief valve with a setting no higher than 200 PSI MUST be installed in the tank for this compressor.
The ASME safety valve must have sufficient flow and pressure ratings to protect the pressurized components from
bursting.
See compressor specifications for maximum operating pressure. Do not operate with pressure switch or pilot valves set
higher than the maximum operating pressure.
Maximum operating pressure is 175 PSI for single stage compressors. Do not operate with pressure switch or pilot
valves set higher than 175 PSI (2-stage).
Never use plastic (PVC) pipe for compressed air. Serious injury or death could result.
Never attempt to repair or modify a tank! Welding, drilling or any other modification will weaken the tank resulting
in damage from rupture or explosion. Always replace worn, cracked or damaged tanks.
Drain liquid from tank daily.
•
Tanks rust from moisture build-up, which weakens the tank. Make sure to drain tank regularly and
inspect periodically for unsafe conditions such as rust formation and corrosion.
•
Fast moving air will stir up dust and debris which may be harmful. Release air slowly when draining
moisture or depressurizing the compressor system.
Spraying Precautions
Do not spray flammable materials in vicinity of open flame or near ignition sources including the compressor unit.
•
Do not smoke when spraying paint, insecticides, or other flammable substances.
•
Use a face mask/respirator when spraying and spray in a well ventilated area to prevent health and fire
hazards.
•
Do not direct paint or other sprayed material at the compressor. Locate compressor as far away from
the spraying area as possible to minimize overspray accumulation on the compressor.
•
When spraying or cleaning with solvents or toxic chemicals, follow the instructions provided by the
chemical manufacturer.
The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot
cover all possible conditions and situations that may occur. It must be understood by the operator that
caution is a factor which cannot be built into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
4
Publicidad
