Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIONAL
ISSUE
No or low
pressure
(initial use)
Will not draw
chemicals
No or low
pressure
(after period of
normal use)
Water leaking at
gun/spray wand
connection
Water leaking
at pump
POSSIBLE CAUSE
Choke in the "Choke"
position.
High pressure hose
is too long.
Spray wand not in
low pressure.
Chemical filter clogged.
Chemical screen not in
cleaning solution.
Chemical too thick.
Pressure hose is too long
Chemical build up in
chemical injector.
Worn seal or packing
Worn or obstructed valves.
Worn unloader piston.
Worn or broken o-ring.
Loose hose connection.
Loose connections.
Piston packings worn.
Worn or broken o-rings.
Pump head or tubes
damaged from freezing.
SOLUTION
Move choke to the "No Choke"
po si tion.
Use high pressure hose under
100 feet (30 m).
See how to Use Spray
Wand paragraph in the
Operation Section.
Clean filter.
Make sure end of detergent
siphon hose is fully submerged
into cleaning solution.
Dilute chemical. Chemical
should be the same
consistency as water.
Lengthen water supply hose
instead of high pressure hose.
Please contact our customer
service department at
www.simpsoncleaning.com
Please contact our customer
service department at
www.simpsoncleaning.com
Please contact our customer
service department at
www.simpsoncleaning.com
Please contact our customer
service department at
www.simpsoncleaning.com
Check and replace.
Tighten.
Tighten.
Please contact our customer
service department at
www.simpsoncleaning.com
Please contact our customer
service department at
www.simpsoncleaning.com
Please contact our customer
service department at
www.simpsoncleaning.com
21 - ENG
Publicidad
