Descargar Imprimir esta página

Publicidad

Enlaces rápidos

WARNING!
To reduce the risk of injury, user must read and understand
the operator's manual for their chemical sprayer and this
instruction sheet. Always wear eye protection with side
shields marked to comply with ANSI Z87.1, as well as any
other safety equipment required due to the solution being
sprayed. Ensure compatibility and fit before using this ac-
cessory. Do not use this accessory if a part is damaged or
missing. If you are not comfortable performing any of the
functions described in these instructions, take your unit to
an authorized service center.
IMPORTANT SAFETY INSTRUCTIONS
 Remove tank from holster before filling tank with chemicals.
 Ensure sprayer is correctly installed in holster and working
properly before using or transporting holster.
 The holster is subject to wear and deterioration and should
be checked each time it is used.
 When carrying the chemical sprayer in the holster with the
wand seated in the sprayer, the wand protrudes outwardly to
the left or right. Be aware of the sprayer wand location and
length at all times so as not to strike a bystander or object.
Fig. 1
CHEMICAL
SPRAYER WITH
1 GAL. TANK
PULVERISATEUR
DE PRODUITS
CHIMIQUES AVEC
RÉSERVOIR DE
3,8 L (1 GAL)
ROCIADOR DE
SUSTANCIAS
QUÍMICAS CON
TANQUE DE
3,8 LITROS
(1 GALÓN)
CHEMICAL
SPRAYER WITH
2 GAL. TANK
PULVERISATEUR
DE PRODUITS
CHIMIQUES AVEC
RÉSERVOIR DE
7,57 L (2 GAL)
ROCIADOR DE
SUSTANCIAS
QUÍMICAS CON
TANQUE DE
7,57 LITROS
(2 GALONES);
CHEMICAL SPRAYER BACKPACK HOLSTER
AC12GAL
Use with RYOBI 1 Gallon and 2 Gallon Chemical Sprayers ONLY
TECHTRONIC INDUSTRIES POWER EQUIPMENT
Anderson, SC 29622 USA
1-800-860-4050
 Do not overreach. Keep proper footing and balance at all
times. Do not use on a ladder or unstable support. Stable
footing on a solid surface enables better control of the product
in unexpected situations.
USING THE CHEMICAL SPRAYER BACKPACK
HOLSTER
See Figures 1 - 2.
 Fill the chemical sprayer and install the battery pack accord-
ing to the instructions in your operator's manual.
 Place the chemical sprayer inside the holster as shown.
NOTE: When using the 1 gallon chemical sprayer, open the
hook-and-loop fastener to allow the hose to exit through the
opening on the side of the holster. When using the 2 gallon
chemical sprayer, the hose should exit at the top.
 Turn the sprayer on following the instructions in your opera-
tor's manual, but DO NOT depress the switch trigger.
 Slip your arms through the holster straps and position the
holster against your back.
 Grasp the lower adjustment straps and pull down until the
holster rests comfortably against the small of your back.
 You are now ready to spray according to the instructions in
your chemical sprayer operator's manual.
Fig. 2
PROPER OPERATING
POSITION
BONNE POSITION DE
TRAVAIL
POSICIÓN CORRECTA
PARA EL MANEJO DE
LA HERRAMIENTA
P.O. Box 1288
www.ryobitools.com
995000672
10-10-18 (REV:01)

Publicidad

loading

Resumen de contenidos para Ryobi AC12GAL

  • Página 1 CHEMICAL SPRAYER BACKPACK HOLSTER AC12GAL Use with RYOBI 1 Gallon and 2 Gallon Chemical Sprayers ONLY  Do not overreach. Keep proper footing and balance at all WARNING! times. Do not use on a ladder or unstable support. Stable footing on a solid surface enables better control of the product To reduce the risk of injury, user must read and understand in unexpected situations.
  • Página 2 Usar el producto SOLAMENTE con rociadores de À utiliser avec les pulvérisateurs de produits chimiques de 3,8 l (1 gal) et 7,57 l (2 gal) RYOBI UNIQUEMENT sustancias químicas RYOBI de 3,8 y 7,57 l (1 y 2 gal), respectivamente AVERTISSEMENT ! ¡ADVERTENCIA!