S.P.E. GREEN6 Manual Del Usuario página 17

User Manual
CHECKING CABLES, GRID, EARTHING
26) Do not transport the battery charger by pulling on the cables as
they could be damaged. Use the handles on the battery charger, if
provided.
27) Before using the battery charger, check that the sleeving on the
mains cable and battery cables is in good condition. Should one of
the cables be damaged, have it replaced by a S.P.E.
ELETTRONICA INDUSTRIALE qualified technician.
28) Check that the input voltage of the battery charger given on the
data plate is in line with the voltage available.
29) Check the compatibility of the mains plug supplied with the
battery charger: the use of adaptors is not recommended (in
Canada it is against the law). If the input plug does not fit the power
outlet, contact SPE ELETTRONICA INDUSTRIALE for the proper
cord set terminating in an attachment plug of the proper
configuration for the power outlet. If the supply cord is damaged, it
must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
30) The battery charger must be plugged into a socket fitted with an
earth wire. Should the socket not be equipped with an earth
connection, do not use the device before having a suitable socket
installed by a qualified technician.
31) The power socket to which the battery charger is to be
connected must be protected by an electrical device by law (fuse
and/or automatic cut-out), capable of absorbing an electrical current
equalling the absorption of current stated on the matriculation
number of the battery charger, increased by 10%.
32) Do not open the battery charger as there are no parts which can
be serviced and/or replaced by the user. Only specialized
personnel, authorized by S.P.E. ELETTRONICA INDUSTRIALE may
carry out servicing which involves opening the actual device.
Electrical/electronic components inside may cause electric shocks
even if the device is not plugged in.
D00582-08 17