Installation Procedure - Toto Kiwami Rennese TS170E Manual De Instrucciones Y Del Propietario

NOTES:
„ Thoroughly flush the water supply line prior to installation�
Make sure the hole for the wall spout water supply pipe is not more
„
than 1" (25mm) in diameter�
1� Put pipe sealing tape
around the threads of
the pipe adapter�
2� Screw the adapter
into the water supply
pipe firmly�
3� Slide the spout onto
the adapter and press it
firmly against the wall�
Take care not to damage
the o-rings�
4� Orient the spout
properly and secure it
with the set screw�

INSTALLATION PROCEDURE

Finished wall
Pipe sealing tape
Pipe adapter
with o-ring
O-rings
Spout
5
Finished wall
.
RECOMMENDED
GAP: 3/16"(5 mm)
Allowable range:
0-3/8"(0 to 10 mm)
Finished wall
Set screw
Allen wrench