Bimar VT7-30B Folleto De Instrucciones página 13

1. Insert the lower part of the body in the base (8) (see the
figure to the right), make sure that the 3 hooks come out
of their relative slots.
Attention: without the base the fan can not be used.
2. Fasten the rear grid (4) to the motor casing, verify
that the handle appears in the back (as shown) and
lock using the appropriate ring nut (3).
3. Insert the fan (10) on the motor shaft (5) and lock with
the appropriate ring nut (12) turning it tightly anti-
clockwise.
4. Couple the front grid (1) to the rear grid (4), blocking
with the ring perimeter plastic; and secure it with the
screw with nut, (11) must be in the lower part. Having
done this, check that the protection grid is firmly
coupled and fastened to the motor.
USE
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed with the selector (9).
1 – Minimum speed 2 – Medium Speed 3-Maximum speed
To turn the fan off, press the "0" key and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (6) located on
the motor body. To stop the motion and keep the ventilator still, press the
button.
Vertical inclination (high-low): it is regulated by gripping the motor body and
orienting it in the direction desired; you will hear "click" that indicate the fan's
various position.
When not in use for long periods, the plug must always be removed from the
socket.
13/36