Saber R50CC0317 Guía De Producto página 5

Connecting Regulator to the LP Cylinder
1. LP cylinder must be properly secured onto grill. (Refer to
assembly section of your grill manual).
2. Turn all control knobs to the
3. Turn LP cylinder OFF by turning hand wheel clockwise to a
Full Stop.
4. Remove the protective cap from LP cylinder valve. Always use
cap and strap supplied with valve.
Safety Relief Valve
5. Hold regulator and insert nipple into LP
cylinder valve. Hand-tighten the
coupling nut, holding regulator in a
straight line with LP cylinder valve so
as not to cross-thread the connection.
Nipple has to be centered
into the LP cylinder valve.
OFF position.
OPD Hand Wheel
Type 1 outlet with
thread on outside
Strap and Cap
Do not use a POL transport
plug (plastic part with external
threads)! It will defeat the
safety feature of the valve.
Connecting Regulator to the LP Cylinder (Con't.)
6. Turn the coupling nut clockwise and tighten to a Full Stop.
The regulator will seal on the back-check feature in the LP
cylinder valve, resulting in some resistance. An additional
one-half to three-quarters turn is required to complete the
connection. Tighten by hand only - do not use tools.
NOTE:
If you cannot complete the connection, disconnect regulator and
repeat steps 5 and 6. If you are still unable to complete the
connection, do not use this regulator!
DANGER
Do not insert any tool or foreign object into the valve outlet
or safety relief valve. You may damage the valve and
cause a leak. Leaking propane may result in explosion,
fire, severe personal injury, or death.
WARNING
Outdoor gas appliance is not intended to be installed in
·
or on a boat.
Outdoor gas appliance is not intended to be installed in
·
or on an RV.
Never attempt to attach this grill to the self-contained LP
·
gas system of a camper trailer or motor home.
Do not use grill until leak tested.
·
If a leak is detected at any time, S TOP and call the fire
·
department.
If you cannot stop a gas leak, i mmediately close LP
·
cylinder valve and call LP supplier or your fire
department!
Hold coupling nut and
regulator as shown for
proper connection to LP
cylinder valve.
5