Remington T22-26274 Manual De Instrucciones página 5

Idiomas disponibles

Replacement combs available. Model: SP254

STEP 1 – Nape of the neck – PICTURE 1

STEP 2 – Back of the head – PICTURE 2

STEP 3 – Side of the head – PICTURE 3

STEP 4 – Top of the head – PICTURE 4

080705_REM_IFU_HC363C_22L.indd 3

ENGLISH

Each comb attachment is marked accordingly on its outside middle surface. (3mm, 7mm,

9mm, 12mm, 18mm, 25mm, left and right ear guide)

INSTRUCTIONS FOR HAIR CUTTING

Note: For even cutting, allow the comb attachment/blade to cut its way through the hair.

Do not force it through quickly. If you are cutting for the ﬁrst time, start with the maxi-

mum comb attachment.

Use 3mm or 7mm guide comb.

Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the

head at the base of the neck.

Slowly lift the clipper, working upwards and outwards through the hair, trimming just a

little at a time.

With the 12mm or 18mm guide comb attached, cut the hair at the back of the head.

With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer

9mm guide comb and continue to cut to the top of the head.

With the 18mm or 25mm guide comb attached, cut hair on top of the head against the

direction in which the hair normally grows.

For longer hair on top, use without a guide comb. Lift the hair on top of the head with a

small hand comb. Cut over the hand comb with the hair lifted or hold the hair between

the ﬁngers to lift it and cut it to the desired length.

Always work from the back of the head.

03.11.2008 19:06:40 Uhr

Hc363c