Uline H-4025 Manual De Instrucciones página 5

OPERATING ISSUE
Machine does not start
Film comes off guide bar
(Display will show OUT OF FILM message)
Heat seals are not strong enough
Heat seals are burning through
Cushions deflate
(This may occur if too much or too little heat is used)
Film not sealing
Film jams
Film winding around heat seal/rollers
Recommended: Daily inspection of belts will help prevent the above issues.
PAGE 5 OF 15
TROUBLESHOOTING
Check that the emergency stop button is not depressed
Check if main power is on
Check that the roll has been properly loaded onto the axle
Check that the film has been wound around the rollers in the correct manner
Check bags for overinflation
Ensure film edge is not dragging against machine chassis
Check bags for overinflation
Increase Heat Adjust setting on the Control Panel
If this does not work, consult Uline Repairs Department
Reduce the Heat Adjust setting on the Control Panel
Reduce the Blower Adjust on the Control Panel as overinflation can cause stretching,
particularly on the smaller cushion size
Change Heat Adjust setting on the Control Panel
Check bags for overinflation, reduce Blower Adjust on the Control Panel
Check for damaged belt
Remove jam and press the START button to restart production
Check for damaged belt or dull blade
Check for damaged belt
Reduce Heat Adjust setting on the Control Panel
1-800-295-5510
uline.com
RECOMMENDATIONS
0221 IH-4025