Denver DAB-24 Manual De Instrucciones página 4

Idiomas disponibles

SWITCHING YOUR RADIO ON FOR THE FIRST TIME

When the radio is connected to the power (AC or DC) for the first time, the display backlight will

be on the greetings and then the clock will be displayed. Press the STANDBY button once will

turn the radio on, the DAB will be automatically selected and perform auto tune quick scan

function. (F.1) (F.2) (F.3)

AC operation

1. Connect the AC power cord to the radio via the AC socket at the back.

2. Connect the AC power cord plug to the AC Mains outlet.

3. Press the STANDBY button on the front panel to turn the radio on.

DC (Battery) operation

In DC operation, the STANDBY button will work as a POWER ON/OFF button. The display will be totally off

when the radio is powered off.

1. Ensure the AC power cord is disconnected from the radio.

2. Installed the batteries (6X1.5V UM2 battery) into the battery compartment.

3. Press the STANDBY button on the front panel to toggle the radio between on and off.

Important Note: To obtain the best performance in DC operation, the use of alkaline batteries is highly

recommended.

LISTENING TO YOUR RADIO

FM MODE

1. To select FM, press the DAB / FM button, the display will show "Switching to FM" and it will automatically

tune to the nearest station. On the top half of the display will show the station name or frequency if the

RDS is not available. (F.4) (F.5)

2. To activate auto search up, press the AUTOTUNE button, it will start scanning up the fre

quency band and stop automatically once a station has been found.

3. To activate auto search down, press and hold the AUTOTUNE button until it starts to scan down the

frequency band.

4. To activate manual search, press the UP or DOWN button.

5. To select audio mode, press the SELECT button,"Audio mode" will be displayed, again press

the SELECT button to toggle between "Auto" or "Mono" selection.

Note: The radio will automatically switch between stereo and mono mode, but you can override

this and switch this function manually which is helpful for poor signal reception.

UK - 3