Omnitronic CDT-150 Manual Del Usuario página 20

4.3 Rear panel
24. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
25. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
26. FADER START-SOCKET
Via the Fader Start-socket, the CD-player can be remotely controlled. If you are using a mixer with
Faderstart-function connect the player with the Control Out-socket. Please note that these sockets must
never be connected with any voltage. Please refer to 6.9 Faderstart.
27. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
28. AC CONNECTION
Plug in the power supply cable here.
29. POWER SWITCH
Press this button to start operation.
5. INSTALLATION
Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.
20/44 10602277_V_1_0.DOC