Next Level Racing FLIGHT STAND PRO Manual De Instrucciones página 12

support@nextlevelracing.com
A)
01
A) Cut the ties securing the Pre-Assembled Flight Stand Pro.
B) Uninstall the pre-installed M8 Bolts and Washers.
A)
02
A) Extend the Vertical Posts to the desired height.
B) Install Bolts and Washers previously uninstalled in Step 01B.
A)
03
A) Loosen the M8 Knobs on the pivot joint and extend the Flight Stand.
B) Align the slot on the Pedal Frame with the threaded insert on the Frame.
B)
B)
B)
WARNING: Keep hands
clear from moving parts to
avoid injury
12
PARTS:
• • Pre-Assembled Flight Stand Pro
PARTS:
Note: The Vertical
Posts should be
• • NIL
extended until a
minimum of 10
threaded inserts are
exposed to allow
installation of Flight
Arms in future steps.
PARTS:
• • NIL