Kenwood DPX530BT Manual De Instrucciones página 24

AUDIO SETTINGS
REAR HPF R - HPF FRQ
R - HPF SLOPE
R - HPF GAIN
SUBWOOFER LPF SW LPF FRQ
SW LPF SLOPE
SW LPF PHASE
SW LPF GAIN
• [SUB-W LEVEL]/ [SUBWOOFER] of [SPEAKER SIZE]/ [SUBWOOFER LPF] of [X ' OVER] is
selectable only if [SUBWOOFER SET] is set to [ON]. ( 19)
• [TWEETER], [REAR HPF] and [SUBWOOFER LPF] of [X ' OVER] is selectable only if a setting
other than [NONE] is selected for [TWEETER], [REAR] and [SUBWOOFER] of [SPEAKER
SIZE]. ( 19)
• Once you have selected the speaker size ([SPEAKER SIZE], 19), the frequency and slope
settings are automatically set for the crossover of the selected speaker.
20
(Refer FRONT HPF, 19.)
30HZ/ 40HZ/ 50HZ/ 60HZ/ 70HZ/ 80HZ/ 90HZ/
100HZ/ 120HZ/ 150HZ/ 180HZ/ 220HZ/ 250HZ:
Adjusts the crossover frequency for the subwoofer
(low pass filter). ; THROUGH: All signals are sent to
the subwoofer.
–6DB/ –12DB/ –18DB/ –24DB: Adjusts the
crossover slope. (Selectable only if a setting other
than [THROUGH] is selected for [SW LPF FRQ].)
REVERSE (180°)/ NORMAL (0°): Selects the phase
of the subwoofer output to be in line with the
speaker output for optimum performance.
–8 to 0: Adjusts the output volume of the
subwoofer.
DISPLAY SETTINGS
Set the dimmer
Press and hold DISP (DIMMER) to turn on or off the dimmer.
• If you have set [DIMMER TIME] ( 21), it will be canceled once you press
and hold this button.
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [DISPLAY], then press the knob.
3 Turn the volume knob to select an item ( 21), then press the knob.
4 Repeat step 3 until the desired item is selected/activated or follow
the instructions stated on the selected item.
5 Press and hold to exit.
To return to the previous setting item, press .