Control Panel; Calculating Charge Time - DSR INDUSTRIAL Serie Manual Del Usuario

12. CONTROL PANEL

12.1 POWER ON (red) LED – The red POWER ON LED lights up when the charger is
plugged in and receiving AC power.
12.2 CHARGING STATUS (yellow and green) LED – The CHARGING STATUS LED glows yellow
when the charger is charging and green when the battery is charged and in maintain mode.
LED Color/Flash Pattern
Red On
Yellow On
Green On
13. OPERATING INSTRUCTIONS
WARNING: Failure to follow instructions may cause damage or an explosion.
Read the entire instruction manual before use.
13.1 Make sure that the charger is unplugged from the AC outlet.
13.2 Connect one of the three optional output cables to the charger output connector.
13.3 Connect the other end of the output cable to the battery.
13.4 Plug the charger into the AC outlet. The POWER ON (red) LED will glow to show that AC
power is present. Then the green and yellow LED will blink once as a self-test to make
sure that the LED is operating properly.
13.5 After three seconds, the CHARGING (yellow) LED will glow to show that charging has
begun. If none of the LEDs glow, or if the CHARGING (yellow) LED does not glow, refer
to the troubleshooting section. Charge time may vary from less than one hour to 12 hours.
13.6 When charging is complete, the CHARGED (green) LED will glow and the charger will
automatically go into maintain mode. If desired, the charger can now be unplugged from
the AC outlet.
NOTE: If the battery has not reached at least 18-volts after five minutes of charging or at
least 24-volts after four hours of charging, the charger will abort the charging process and
turn the yellow LED off.

14. CALCULATING CHARGE TIME

To determine the time needed to fully charge your battery, you must first determine the
battery's charge level with a hydrometer or electronic Percent-of-Charge Tester. The
following table will help you convert hydrometer readings to percent of charge values.
Specific Gravity
1.265
1.225
1.155
1.120
When the percent of charge and the Amp Hour (AH) rating of your battery is known, you
can calculate the approximate time needed to bring your battery to a full charge.
Explanation
AC Power Present
Charging
Charge Complete
Percent of Charge
100%
75%
25%
0%
• 6 •
Percent of Charge Needed
0%
25%
75%
100%