Control Panel - DSR PRO Serie Manual Del Usuario

1. Carefully lay the charger on its front to prepare for assembly.
2. Assemble the foot (Item 6) using two ¼-20 screws (Item 5) and tighten securely.
3. Attach the two axle brackets (Item 1) using one 10-32 screw (Item 4) in each.
The brackets should have one end hooked into the slot in the charger base.
Be careful not to drop the brackets inside of the charger case.
Do not completely tighten the screws (Item 4) at this time.
4.
Slide the axle (Item 2) into the brackets (Item 1) until centered on the charger.
5. Slide one wheel (Item 3) onto the axle with the recessed hub facing out as shown.
6. Insert the pin (Item 8) through the axle hole.
7. Repeat this process for the other wheel and when both wheels have been pinned
to the axle, finish tightening the two axle bracket screws (Item 4).
8.
Snap the axle caps (Item 7) onto each wheel to cover the pin and axle.
9. Lift the charger upright so that it rests on the wheels and foot.
10. Remove the two top side screws (Item 9) from each side of the charger.
11. Verify that the foam handle grip (Item 12) is on the handle assembly (Item 10).
Install it if needed.
12. Insert the fiberglass clamp rod (Item 11) into the pierced holes on the inside
of the handle (Item 10).
13. Align the handle assembly (Item 10) with the charger and reinstall the side screws
(Item 9). Do not over-tighten.
14. The charger assembly is now complete. The battery clamps can be clamped to the
fiberglass rod (Item 11), for convenient storage.
15. Do not attach the clamps to the foam area of the handle; this will damage the foam grip.

11. CONTROL PANEL

NOTE: Not all controls are available
on all models.
CHARGE RATE SELECTOR SWITCHES
Use the charge rate selector switch to select
the charge rate or engine start setting.
• 1.5A, 2A, 4A and 5A Slow Charge –
For small batteries, such as those
commonly used in garden tractors,
snowmobiles and motorcycles.
• 10A, 20A, 30A and 35A Fast and 40A,
60A, 65A and 80A Rapid Charge –
For charging automotive, marine and
deep-cycle batteries. Not intended for
industrial applications.
• 125A, 180A, 200A, 225A, 250A and
300A Engine Start – Provides high
amperage for cranking an engine with a
weak or run down battery. Always use in
combination with a battery.
Model PSW-61224 employs a
7-position rotary switch.
You may select the output voltages of 6,
12, or 24 volts for charging the batteries
of those voltages or battery combinations
connected in series (not parallel) in which
the sum of the battery voltages adds up
to the range selected. Each voltage range
offers a high or low amp charge rate. The
8
• •
12
10
11
9