Publicidad
Idiomas disponibles
Idiomas disponibles
Water Supply And Drain
Cold water connection
Connect the cold water supply hose
to a threaded 3/4(inch) connector
and make sure that it is fastened
tightly in place.
If the water pipes are new or have
not been used for an extended
period of time, let the water run to
make sure that the water is clear.
This precaution is needed to avoid
the risk of the water inlet to be
blocked and damage the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The hose's system
guarantees its intervention by blocking the flow of water in case of the
supply hose breaking and when the air space between the supply hose
itself and the outer corrugated hose is full of water.
WARNING
A hose that attaches to a sink spray can burst if it is installed on the
same water line as the dishwasher. If your sink has one, it is
recommended that the hose be disconnected and the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses completely out from storage
compartment located at rear of dishwasher.
2. Tighter the screws of the safety supply hose to the faucet with
thread 3/4inch.
3. Turn water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
ordinary
supply
hose
17
safety supply
hose
V.3
Publicidad
