Publicidad
Idiomas disponibles
Idiomas disponibles
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the
water, which would have a detrimental or adverse effect on the operation
of the appliance. The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in
your area. Your local Water Authority can advise you on the hardness of
the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt
consumed based on the hardness of the water used. This is intended to
optimise and customise the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Close the door and switch on the appliance;
2.Press the Rapid button for more than 5 seconds to start the water
softener set model within 60seconds after the appliance was switched on;
3.Press the Rapid button again to select the proper set according to
your local environment, the settings will change in the following
sequence: H1->H2->H3->H4->H5->H6;
4.
Press the Power button to end the setting mode.
WATER HARDNESS
German French
British
ºClarke
ºdH
ºfH
0 - 5
0 - 9
7 - 14
6 - 11
10 - 20
15 - 21
12 - 17
21 - 30
22 - 28
18 - 22
31 - 40
29 - 42
23 - 34
41 - 60
43 - 69
35 - 55
61 - 98
1. ºdH =. 1,25 ºClarke = 1,78ºfH = 0,178 mmol/l
Factory setting: H3
1) Every cycle with a regeneration operation consumes additional 2.0
litres of water, the energy consumption increases by 0.02 kWh and
the program extends by 4 minutes.
Mmol/l
0 - 6
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
Water softener
level
H1: Rapid Light
H2: 90 Min Light
H3: Rapid, 90 Min Light
H4: ECO Light
H5: ECO, Rapid Light
H6: ECO, 90 Min
Light
35
Regeneration
occurs every
consumption
X program
sequence 1)
No regeneration
10
5
3
2
1
Salt
(gram/cycle)
0
9
12
20
30
60
V.3
Publicidad
