Publicidad
•
Take out the hex screws and disassemble the blade set. Brush and clean out
accumulated hair. Oil the contact surfaces of the blades and then reassemble.
•
If the blades are not correctly aligned, cutting efficiency will be impaired.
•
Place a few drops of clipper oil onto the blades gliding surface. Wipe off excess oil.
CLEANING CAUTIONS
•
Ensure the appliance is switched off and unplug from the main outlet before cleaning.
•
Only the attachment guide combs and blade set may be removed from the product for
cleaning.
•
Do not use harsh or corrosive cleaners on the units or their blades.
•
Suitable for cleaning under an open water tap.
BATTERY REMOVAL
•
The battery must be removed from the appliance before it is scrapped.
•
The appliance must be disconnected from the supply mains when removing the
battery.
•
Ensure that the clipper is discharged of all power and disconnected from the mains
•
Lift or pry the deco plate on the lower portion of the clipper and unscrew 2 screws
located on the back housing of the clipper.
•
Remove 4 screws of inner housing to expose batteries
•
Lift or pry the cover plate on the bottom of the battery chamber.
•
Remove the 2 batteries and printed circuit board assembly from the battery chamber.
•
Cut the tabs on both ends of the battery and remove it from the printed circuit board.
•
The battery is to be disposed of safely.
•
Note: these clippers are not intended for professional use.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
NO
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
AE
7
Publicidad
