Metra 95-9700WR Instrucciones De Instalación página 8

INSTALLING THE INTERFACE
It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the key in the off position:
1. Connect the 95-9700WR harness into the interface, and then to the wiring harness in the
vehicle.
2. Connect the antenna adapter (provided), and complete all necessary connections to the radio.
3. Do not connect the ASWC-1 just yet, leave it disconnected.
Attention! To prevent error codes, all electronic devices including the headlight and turn
signals must be connected before proceeding to the next step.
INITIALIZING THE INTERFACE
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. Turn the key to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
2. Test the radio for proper operation.
3. Turn the key to the off position.
8
INITIALIZING THE INTERFACE
4. Connect the ASWC-1 and program it:
a. Turn the ignition on, the LED will start flashing rapidly.
Note: If the LED did not start flashing rapidly, press the reset button for 3 seconds .
b. Tap the Volume Up button on the handlebar at a moderate pace until the L.E.D. stops
flashing rapidly.
c. After a few seconds the LED should stop flashing rapidly, and then go out for
approximately 2 seconds.
d. After approximately 2 seconds there will be a series of 7 Green flashes, (6) short, and (1)
long. The (1) long flash represents that the ASWC-1 detected the vehicle.
Tip: Knowing this will help to troubleshoot, if need be.
e. The LED will pause for another 2 seconds, and then flash Red up to (18) times depending
on which radio is connected to the interface. Refer to the L.E.D. feedback section for
information.
f. This is the end of the auto detection stage. If the ASWC-1 detected the radio and vehicle
successfully, the L.E.D. will light up solid.
g. Test the handlebar controls for proper operation. Refer to "Handlebar Control Settings"
before proceeding onto the next step.
5. Turn the key to the off position.
FINAL ASSEMBLY
1. Reassemble the fairing in reverse order of disassembly.
(CONT)
|
386.257.1187 MetraOnline.com