Publicidad
Idiomas disponibles
Idiomas disponibles
L.E.D. Feedback
The (18) Red L.E.D. flashes represent which brand radio the ASWC-1 is connected to. Each
flash represents a different radio manufacturer. For example, if you are installing a JVC radio,
the ASWC-1 will flash Red (5) times, and then stop. Following is a legend that dictates which
radio manufacturer corresponds to which flash.
L.E.D. Feedback Legend
1 flash - Eclipse (Type 1) †
8 flashes - Visteon
2 flashes - Kenwood ‡
9 flashes - Valor
3 flashes - Clarion
(Type 1) †
10 flashes - Clarion
4 flashes - Sony / Dual
5 flashes - JVC
(Type 2) †
6 flashes - Pioneer / Jensen
7 flashes - Alpine *
11 flashes - Metra OE
* Note: If the ASWC-1 flashes Red (7) times, and you do not have an Alpine radio connected to it, that
means the ASWC-1 does not detect a radio connected it. Verify that the 3.5mm jack is connected to the
correct steering wheel jack/wire in the radio.
** Note: The AX-SWC-PARROT is required (sold separately). Also, the Parrot radio must be updated to
rev. 2.1.4 or higher through www.parrot.com.
† Note: If you have a Clarion radio and the handlebar controls do not work, change the radio type to
the other Clarion radio type; same for Eclipse. The following section explains how to do this.
‡ Note: If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC radio,
change the radio type to a Kenwood. . The following section explains how to do this.
HANDLEBAR CONTROL SETTINGS
12 flashes - Eclipse
(Type 2) †
13 flashes - LG
14 flashes - Parrot **
15 flashes - XITE
16 flashes - Philips
17 flashes - TBD
18 flashes - JBL
Attention: The Axxess Updater App can also be used to program the following (3) sub-sections
as well, pending that the interface has been initialized and programmed.
Radio Type
If the L.E.D. flashes do not match the radio that is connected, change the radio type.
1. After (3) seconds of turning the key on, press and hold the Volume-Down button on
the handlebar until the L.E.D. in the ASWC-1 goes solid.
2. Release the Volume-Down button; the L.E.D. will go out indicating we are now in
Changing Radio Type mode.
3. Refer to the Radio Legend to know which radio number you would like to have
programmed.
4. Press and hold the Volume-Up button until the L.E.D. goes solid, and then release.
Repeat this step for the desired radio number.
5. Once the desired radio number has been selected, press and hold the Volume-Down
button on the handlebar until the L.E.D. goes solid. The L.E.D. will remain on for
about (3) seconds while it stores the new radio information.
6. Once the L.E.D. goes off, the Radio Type mode will then end. You can now test the
handlebar controls.
Note: If at any time the user fails to press any button for a period longer than ten
seconds, this process will abort.
REV. 9/10/2020 INST95-9700WR
9
Publicidad
