EINHELL FORTEXXA 18 TH Manual De Instrucciones página 21

10. Troubleshooting
Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your tool fails to work properly. If the problem still persists after working through the list then please
contact your nearest service workshop.
Problem
Chainsaw does not
work at all.
Chainsaw operates
intermittently.
Saw chain is dry.
Chain brake does
not work.
Chain/bar are hot.
Chainsaw
juddering, vibrating
or not sawing
properly.
Anl_Fortexxa_18_20_SPK7_USA.indb 21 Anl_Fortexxa_18_20_SPK7_USA.indb 21
EN
Possible cause
- Chain brake has been triggered.
- No power supply.
- Loose connection (external).
- Loose connection (internal).
- On/Off switch defective.
- No oil in the tank.
- Oil tank cap breather blocked.
- Oil nozzle blocked.
- Problem with the switch mechanism
in the front hand guard.
- No oil in the tank.
- Oil tank cap breather blocked.
- Oil nozzle blocked.
- Blunt chain.
- Chain tension too loose.
- Blunt chain.
- Worn chain.
- Saw teeth pointing in the wrong
direction.
- 21 -
Solution
- Pull the chain brake back to the
normal position.
- Check the power supply.
- Consult a service center.
- Consult a service center.
- Consult a service center.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Consult a service center.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil nozzle.
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Reinstall the saw chain with the
teeth facing in the correct direction.
29.11.2022 14:42:44 29.11.2022 14:42:44